Setup; Electrical Connection - Hoshizaki DCM-300BAH Instruction Manual

D. Setup
1) Position the appliance in the selected permanent location. If applicable, attach optional
6" legs or attach to an optional stand. If attaching to a stand, refer to the instructions
included with the stand. If removing the drip tray, refer to the instructions included with
the HS kit (HS-5003 for DCM-751 B_H or HS-5002 for DCM-751B_H-OS).
2) Level the appliance in both the left-to-right and front-to-rear directions. If using optional
6" legs or an optional stand, adjust the legs to make the appliance level.
3) If mounting flat to a counter, seal the perimeter where the appliance contacts the
counter with approved caulk compound in a smooth and easily cleanable manner.
4) Replace the panels in their correct positions.
E. Electrical Connection
For All Models
• Electrical connection must be hard-wired and must meet national, state, and local
electrical code requirements. Failure to meet these code requirements could result
in death, electric shock, serious injury, fire, or damage.
• The appliance requires an independent power supply of proper capacity. See
the nameplate for electrical specifications. Failure to use an independent power
supply of proper capacity can result in a tripped breaker, blown fuse, damage to
existing wiring, or component failure. This could lead to heat generation or fire.
• THE APPLIANCE MUST BE GROUNDED. Failure to properly ground the
appliance could result in death or serious injury.
• Electrical connection must be made in accordance with the instructions on the
"WARNING" tag, provided with the pig tail leads in the junction box. See Fig. 3.
• Usually an electrical permit and services
of a licensed electrician are required.
• The maximum allowable voltage variation
is ±10 percent of the nameplate rating.
• The white lead must be connected to the
neutral conductor of the power source.
NOTICE! Miswiring may result in
damage to the appliance.
• The opening for the power supply
connection is 7/8" DIA to fit a 1/2" trade
size conduit.
WARNING
Fig. 3
15
WARNING

ELECTRICAL CONNECTION

THIS UNIT MUST BE GROUNDED
Failure to properly ground or wire
this unit could result in death,
serious injury, or severe damage
to the icemaker. The white lead
must be connected to the neutral
conductor of the power source.
See diagram below.
115-120/60/1
JUNCTION BOX
L
BROWN
N
WHITE
4A4766-010