THOMSON SpeedTouch 716v5 (WL) User Manual page 64

Chapter 4
Voice over IP
Command overview
56
To use the service:
Conference Call (3 Party)
CLIR on call basis
Forced FXO
In the table below all standard service codes of the telephony services are listed. On
your SpeedTouch™ these might be different, depending on your provider.
Phone command:
R 0
R 1
R 2
R 3
R 4
*31*
*01*
Proceed as follows:
To set up a conference call:
Call person A.
1
Dial R, 2. Person A is put on hold.
2
Wait for the dial tone.
3
Dial the number of person B.
4
Person B picks up the phone.
5
Dial R, 3.
6
Once the conference call has been established, you
can:
Dial R, to put the 2 calls on hold.
1
2
Dial R, to retrieve the 2 held calls.
2
3
It is possible to hide your phone number for one
particular call. Dial directly followed by the
*31*
phone number of person A.
To make a phone call over the regular telephone
line:
Dial *01*.
1
Wait for the dial tone, and then dial the phone
2
number of person A.
Is used to:
drop a held call
reject an incoming call
terminate an active call and switch to the
waiting or held call
put a call on hold
switch between active and waiting or held call
put a conference call on hold
establish a 3-way conference call
transfer a call
make an anonymous call (use CLIR) on call
basis
use the regular telephone line
E-DOC-CTC-20050401-0008 v1.0