Routed Pppoi - THOMSON SpeedTouch 605 User Manual

Chapter 5
Expert Configuration

5.4.4 Routed PPPoI

Availability
Introduction
Creating a Routed
PPPoI connection entry
Additional configuration
144
The ISDN modem is only fully functional after activating the ISDN software module
with the ISDN software module activation key. For more information, see
"5.2.10 Add-on" on page
The Routed PPPoI configuration page allows you to add new Routed PPPoI
connection entries or to change settings of existing entries.
To add a Routed PPPoI connection entry:
1
Click New.
2
In the Interface box, type a unique interface name.
3
In the ISP profile list, click:
The name of a profile if you want to use an existing profile.
New to create a new profile. Type the name you want to assign to this
profile in the Enter Name box.
These ISP profile contain the ISDN parameters.
4
Type user name and password for the account at the ISP.
5
If needed, enter the ISDN parameters of your ISP.
6
Click Apply.
Once created, per Routed PPPoI connection, additional configuration is possible by
clicking:
1
Routing
2
Other
These parameters can only be modified when the link is down. Take the link
down first by clicking Hang-up.
Routing
Following fields are available:
Destination:
Controls the networks that can be reached via this particular PPP connection.
Specify the remote host or network in prefix notation. e.g. 172.16.0.0/16.
Label:
Allows you to assign a label to this connection.
120.
E-DOC-CTC-20051017-0151 v1.0