[B] Writing And Update Software - Marantz ZR6001 Service Manual

[B] WRITING AND UPDATE SOFTWARE

Software for MAIN CPU, SUB CPU, DSP and PLC firmware can be updated.
Have update application software. ("H8Download.exe", "fdtv30300.exe (FDT3.3) or latest version", "PlcFirmUpdate.exe"
and "UpgradeDSP.exe")
There are four mode of download, regarding to the target of software as bellow.
• Mode 1: Update DSP's software to 4M Flash-ROM.
This mode is to update the software for DSP.
The target devise is 4M Flash-ROM (IC20) on CUP11859Z (DSP PWB).
The unit needs to be set update condition, by three front keys.
The updating of software takes about 2 minutes.
• Mode 2: Update MAIN CPU's software to internal Flash-ROM.
This mode is to update the software for MAIN CPU.
The target devise is internal flash ROM of CPU (IC28) on CUP11859Z (DSP PWB).
The unit needs to be set to writing condition, by pushing internal switch from rear panel.
The updating of software takes about 2 minutes and 30 seconds.
• Mode 3: Update SUB CPU's software to internal Flash-ROM.
This mode is to update the software for SUB CPU.
The target devise is internal flash ROM of CPU (IC19) on CUP11861Z (PLC PWB).
The unit needs connection to download JIG.
The unit needs to be set update condition, by three front keys.
The updating of software takes about 15 seconds.
• Mode 4: Update PLC's firmware to PLC MODULE.
This mode is to update the firmware for PLC.
The target devise is PLC MODULE (MLD011TM-C2 00MZK11CW0010).
The unit needs connection to download JIG.
The unit needs to be set update condition, by three front keys.
The updating of software takes about 1 minute.
NECESSARY EQUIPMENT
The following items are required for updating.
Windows PC (OS: Windows2000 or WindowsXP) with Serial port.
RS-232C Dsub-9 pin cable (female to female/straight type)
Update software to MAIN CPU. (H8Download.exe, etc... in H8Upgrade folder)
Update software to SUB CPU. (update data in SUB CPU folder)
Update software to DSP. (UpgradeDSP.exe, etc... in DSP folder)
Update firmware to PLC. (PlcFirmUpdate.exe, etc... in PLC firmware folder)
Flash Development Toolkit 3.3 or latest version (fdtv30300.exe or latest version)
PLC download JIG (90M-ZR6001JIG)
Use RS232C Dsub-9 pin cable (female to female/straight type) to connect PC and the RS-232C port in rear panel of the
unit, when updating MAIN CPU and DSP.
Use RS232C Dsub-9 pin cable (female to female/straight type) to connect PC and the download JIG, when updating SUB
CPU and PLC firmware.
Serial port on PC needs to be set by dialog box for each program. Serial port can be set from COM1 to COM5.
26