Skoda FABIA 2000 Workshop Manual page 188

94
Removing and installing the headlight
range control motor
Removing and installing ⇒ Chap. 94-1
Removing and installing the transmitter
with rear controller
Removing
–
Raise vehicle.
–
Disconnect controller.
–
Unscrew the fastening screws of the transmitter -ar-
row A- (21 Nm) and the tension rod -arrow B- (16 Nm)
Installing
–
Carry out the installation in the same way in reverse
order.
Installing the rear transmitter
Note
The rear transmitter cannot be installed mechanically, it
can only be installed intitiating the basic setting ⇒ Chapt.
94-10.
Connection identification of the Xenon
headlamps
Connection identification of the controller
1 - Terminal 31
2 - Terminal 15
3 - not assigned
4 - Vehicle speed signal
5 - K cable of diagnosis
6 - Terminal 56 - Starting signal for low beam lights
7 - Step Motor
8 - not assigned
Connection identification of the headlight
1 - Terminal 56b - low beam lights
2 - not assigned
3 - not assigned
4 - Terminal 31 step motor ground
5 - Terminal 56a - main light beam
6 - Signal of the transmitter at the rear axle.
7 - Terminal 58 - Side light
8 - Terminal 31 Main beam and side lights ground.
9 - Turn signal lamp
10 - Low beam light and turn signal lamp grounds
94-9
4
page
Headlight - xenon light
FABIA 2000 Electrical System
B
A
S94-0145
Edition 06.03
S00.5304.09.20