Sdm Template Configuration - Cisco Catalyst 3850 Deployment Manual

Resource
Input NetFlow flows
Output NetFlow flows

SDM Template Configuration

Use the sdm prefer configuration command to change the SDM template:
Reload the switch to activate the SDM template change.
Use the show sdm prefer command to confirm the current SDM template setting after the reload:
These numbers are typical for L2 and IPv4 features. For features such as IPv6 that consume double the entry size,
only half as many entries can be created.
© 2013 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information.
Advanced VLAN
Template Template
8192 16384
16384 8192
Resource Explained
Maximum ingress NetFlow flows
Maximum egress NetFlow flows
Page 43 of 54