Maintenance; Cleaning; Replacing Worn Drive Belts - Burgess BK3 Specification And Operating Instructions

,I
t'
8
Maintenance
THIS PRODUCTSHOULD BE DISCON-
NECTED FROMTHE MAINS SUPPLY
WH ILST CARRYI NG OUT MAINTENAN-
CE, ADJUSTMENT OR THE REPLACE-
MENTOFANYWORN PARTS.
The 810 Mk.1I 8andsaw is supplied with
a new, all-British motor.
Manufactured to the most stringent
electrical and mechanical specifications,
it is more powerful than its predecessor
and is equipped with- a a power take-off
paint, at the rear, to accept the latest
Burgess accessory, the Disc Sanding
Attachment.
Contents:-
(i) 180mm (7") diameter sanding disc
(ii) Adjustable angle table from
0
0
to
45
0
which accepts the Burgess mitre
fence accessory
The purchase of a Disc Sanding
Attachment will extend even greater
versatility
to
the range of useful
applications for which your
BK3
Mk,11
may be used. The Attachment is
available now from your local stockist,
part no. 580800.
Cleaning
Dust ejection slots at the bottom of the
frame do much to minimise the accumula-
tion of sawdust but they may become
obstructed after prolonged periods.
Therefore, after every few hours of running,
the front cover plate should be removed
and accumulations of sawdust be
removed both from the interior and from
around the machine, either by brushing,
by blowing with compressed air, or by
removing with a vacuum cleaner.
lubrication
Occasionally apply one or two spots of
good quality machi ne oil to the spindles of
each of the three wheels.
ReplaCing worn drive belts
With the machine disconnected from the
mains and the blade removed a worn driv-
ing belt may be replaced by slackening
the two motor fixing studs, easing the belt
tension, and running it off both pulleys.
When a replacement belt has been fitted
apply sutlicient tension as described pre-
viously under the section describing
speed change.