Fitting The Saw Table - Burgess BK3 Specification And Operating Instructions

j
~.
Fitting the saw table
1. Fit the semi-circular mounting arc to
the underside of the Bandsaw table
using the two screws provided.
2. Remove the table locking wing nuts
and washers from the two studs at the
rear of the machine and ensure the
angle indicator does not restrict the
table from being fitted
3. Hold the table horizontal with its slot in
Iine with the back of the blade. Carefully
gUide the table into position so that the
slot is towards you and the studs both
protrude through the slot in the mount-
ing arc underneath the table.
4. Replace the table locking wing nuts
with the washers beneath them. Press
down lightlyon the table to keep it in
contact with the table level adjustment
cam while tightening the wing nuts.
5. Set the angle indicatorto read 0" and
secure.
6. Check that the coloured centre plate
insert is correctly posiltoned in its
recess and that its upper surface is
flush with that of the table.
7. The table may be tilted at any angle
required up to 45 0
;
the angle is
Indicated on the mounting arc. To return
It to the nonzontai bnng the underneath
of the table back into contract with the
cam. A set square
IS
useful to check the
level of the table In relation to the saw
blade. Should the table not be square to
the blade release the screw holding the
cam and adjust the table. Then push the
cam up to the table and re-tighten.
To assist in the control of the work
positioned on the table two fences are
available as optional accessories:
1. The Rip Fence is for rip and cross
cutting.
2. The Mitre Fence is invaluable for all
applications involving mitre joints.