Samsung SV-A17GV Service Manual page 17

Alignment and Adjustment
5-2-2 (b) IF THE NORMAL REMOTE CONTROL
ASS'Y OF X-7/X-8(DX7-R/DX7-RC/
DX8-R/DX8-RC) CHASSIS ("IS"
CHASSIS AND "C" CHASSIS) IS
AVAILABLE
Note 1 : Three kinds of remote control ass'y are used
for X-7/X-8(DX7-R/DX7-RC/DX8-R/
DX8-RC) chassis.
1. Three kinds of remote control ass'y are remote
control ass'y of "C" chassis, normal remote control
ass'y of "IS" chassis, and multi remote control
ass'y of "IS" chassis.
2. All adjustments are adjusted by remote control
ass'y of "C" chassis and normal remote control
ass'y of "IS" chassis.
3. For the identification of remote control ass'y by
chassis, See page 5-1 and page 5-2.
Note 2 : How to use the "TEST" button.
1. Disattach the inlay of remote control ass'y.
(See Fig. 5-1, 5-2 and 5-3)
2. Press the "TEST" button with the pincers and the
precise driver as shown in Fig. 5-1, 5-2 and 5-3)
1. When using the "INPUT" button of remote
control ass'y;
1) Simultaneously press the "INPUT" button and "1"
button in PB mode.
This will adjust the tracking center automatically.
2) Set the tracking preset using the "FINE(Tracking,
TRK)" button of remote control.
3) After adjustment is completed, press the
"POWER" button to release.
2. When using the "TEST" button of remote
control ass'y ;
1) Simultaneously press the "TEST" button and "5"
button in PB mode.
This will adjust the tracking center automatically.
2) Set the tracking preset using the "FINE (Tracking,
TRK) button of remote control.
3) After adjustment is completed, press the
"POWER" button to release.
5-4 Samsung Electronics