Connecting To The Smc Sdi Cli Of The Fpm Module In Slot 3; Changing The Management Module Admin Account Password; Connecting To The Fortios Cli Of The Fim Module In Slot 2 - Fortinet FortiGate-7060E System Manual

FortiGate-7060E Management Modules

Connecting to the FortiOS CLI of the FIM module in slot 2

Use the following steps to connect to the FortiOS CLI of the FIM module in slot 2:
1. Connect the console cable supplied with your chassis to Console 1 and to your PC or other device RS-232 console
port.
2. Start a terminal emulation program on the management computer. Use these settings:
Baud Rate (bps) 9600, Data bits 8, Parity None, Stop bits 1, and Flow Control None.
3. Press Ctrl-T to enter console switch mode.
4. Repeat pressing Ctrl-T until you have connected to slot 2. Example prompt:
<Switching to Console: FIM02 (9600)>
5. Login with an administrator name and password.
The default is admin with no password.
For security reasons, it is strongly recommended that you change the password.
6. When your session is complete, enter the exit command to log out.
Connecting to the SMC SDI CLI of the FPM module in slot 3
Use the following steps to connect to the management module SMC SDI CLI:
1. Connect the console cable supplied with your chassis to Console 1 and to your PC or other device RS-232 console
port.
2. Start a terminal emulation program on the management computer. Use these settings:
Baud Rate (bps) 9600, Data bits 8, Parity None, Stop bits 1, and Flow Control None.
3. Press Ctrl-T to enter console switch mode.
4. Press Ctrl-R to switch to the management module SMC SDI CLI switching mode.
5. Repeat pressing Ctrl-R until you have connected to slot 3. Example prompt:
<Switching to Console: FIM03-MC (9600)>
6. Login with an administrator name and password.
The default administrator name and password are admin/admin.
For security reasons, it is strongly recommended that you change the password.
7. You can begin entering commands at the admin@FPM03-MC # prompt.
8. When your session is complete, enter the exit command to log out.

Changing the management module admin account password

Use the following procedure to change the management module admin account password.
1. Enter the following command to show all users and their user IDs.
user list
The output should show that the admin user has a user ID of 2.
2. Use the command user set password <user-id> [<password>] to add a password for the admin
account. For example:
user set password 2 <password>
FortiGate-7060E System Guide
Fortinet Technologies Inc.
Connecting to the FortiOS CLI of the FIM module in slot 2
30