Calibration Compensation Function - Sekonic FLASHMATE L-308X Operating Manual

6-2

Calibration Compensation Function

This meter has been calibrated to Sekonic standards. However, compensation may
be necessary to calibrate the meter to camera specifications or to match the display to
another exposure meter. Calibration compensation can be made in precise 1/10 step
increments in a +/-1.0 EV range.
Operation
1.
Set the Display mode (PHOTO, HD CINE or CINE) in advance.
NOTE
● Calibration compensation can be set independently in each Display mode. Select the
Display mode in advance in the custom setting function. ( ➡ P31 )
2.
To enter the calibration compensation
mode, hold the ISO Button and press
the POWER Button to turn the meter ON.
"CAL" will appear at the upper right of
the LCD. The Display mode will appear
at the lower left of the LCD. The current
compensation amount will appear at the
lower right of display. (Default setting is
"0.0")
3.
Select the compensation value by
pressing the UP or DOWN Button.
NOTICE
● Plus compensation results in the increased exposure (the image becomes brighter), and
minus compensation results in the decreased exposure (the image becomes darker).
● Calibration compensation should be made after sufficient testing of the camera or film in
use indicates the necessity.
4.
Press POWER Button to exit Calibration compensation mode.
POWER Button
MODE
ISO Button
33
6. Advanced Functions
●
UP Button
DOWN Button