Page 1
Instruction Manual ® Nova-Pro LED Stroboscopes / Laser Tachometers 15 Columbia Drive • Amherst, NH 03031 USA Phone: (603) 883-3390 • Fax: (603) 886-3300 E-mail: support@monarchinstrument.com Website: www.monarchinstrument.com...
Page 2
Contact distributor for appropriate product return procedures. In order to comply with EU Directive 2012/19/EU on Waste Electrical and Electronic Monarch Instrument’s Limited W arranty applies. Equipment (WEEE): This product may contain material which could be hazardous to See www.monarchinstrument.com for details.
TABLE OF CONTENTS: BATTERY PACK ............19 INTRODUCTION ............4 USER INTERFACE ............6 7.1 Low Battery Functionality ......... 19 4.2 Charging the Battery Pack ......... 20 GETTING STARTED ............ 8 AC POWER OPTION ..........20 3.1 Power ................. 8 WALL POWER SUPPLIES ..........
Accessory) inspection. Can also be used in rotating objects (Tach Mode). Tachometer Mode. The features of the Nova-Pro 100 are highlighted in Figure 1 and Table 1. Trigger Used to activate the unit (when power is on) Figure 1 Nova-Pro 100 Features...
2. USER INTERFACE 6-digit display used to display flash rate and other numeric values The Nova-Pro 100 user interface consists of a large display, dedicated keys on the user interface panel and a trigger to activate the unit when Lock icon—Active when the device is locked on.
3. GETTING STARTED 4. MODES OF OPERATION Power The Nova-Pro 100 has a single mode of operation: STROBE, UNLESS the optional Laser Module is installed in the unit. This adds two additional The battery powered Nova-Pro has a removable modes: Battery Pack that should be charged before use (see LASER—uses the laser beam to trigger the stroboscope so that the...
Object rotating at 3,000 RPM, using Flashes Per Minute (FPM) to determine speed Figure 3 Object rotating at 3000 RPM Press or to Press or to increase or decrease change the digit that ( 2) (X2) (X2) (X2) the value of the...
Figure 4 Using the Laser Module 5. MENUS Menu Overview 3600 3600 The menu that shows is dependent on the current operating mode of the unit and whether the Laser Module is installed. TACH CAUTION: • AVOID EXPOSURE—LASER RADIATION IS EMITTED FROM THIS APERTURE •...
Press the MENU button to enter menu options and make selections. rate. If the adjustment was in time, the strobe will have a fixed duration irrespective of the flash rate. Press the POWER button to escape or back out of the menus. On-Target icon will show which menu option is selected.
A value of 600 will be displayed as 600, 600.0, 600.00, 600.000 de- wider the pulse, the brighter the flash from the LEDs appears to be. There is pending on the setting. however, a downside to the wider pulses. All strobes work by giving short bursts of light (the pulse width) at a rapid repetition rate (the flash rate).
When setting the pulse duration in degrees, what you set is what you get. Refer to the image on the right for the difference between a 1° When ordered as such, the Nova-Pro 100 comes with one and 5° (of rotation) flash duration.
Nova-Pro Charging 9. WALL POWER SUPPLIES Station (shown right) and power Power The wall power supplies provided with the Nova-Pro 100 have inter- supply provided. Supply changeable plugs allowing them to be used with AC outlets in different...
10. SPECIFICATIONS Humidity: Maximum relative humidity 80% for temperatures up to 31 °C decreasing linearly to 50% relative humidity at 40 °C. Rating: Splash proof—IP 54 Category: 10.2 Compliance 10.2.1 Battery Compliance The Lithium-Ion battery packs used in this product meet the requirements of UN DOT 38.3.
11. OPTIONS and ACCESSORIES Laser Module Optional Laser Module enables the Nova-Pro 100 to be used as a laser tachometer or to synchronize the strobe flash to a remote target. Laser Module Optional docking station for Laser Module which can...
Need help?
Do you have a question about the Nova-Pro 100 and is the answer not in the manual?
Questions and answers