Using External Power; Connecting The Ac Adapter - Minolta CL-200 Instruction Manual

Using External Power

WARNING
Use only the AC adapter specified for this instrument, and connect the adapter only to
an AC outlet of rated voltage and frequency. Use of a different adapter or incorrect
power source may cause damage to the instrument and adapter, and poses risk of fire
or electric shock.
Disconnect the AC adapter from the outlet if you are not going to use the instrument
again for a prolonged period. If the plug area is dirty or damp, clean it before inserting the
plug into the outlet. Insertion of the plug while it is dirty or wet constitutes a fire hazard.
Do not continue using the instrument (or the AC adapter) if the instrument (or adapter)
becomes damaged or starts to emit smoke or unusual odors. Continued use under
these conditions constitutes a fire hazard. Switch the instrument off immediately and
remove the batteries (or disconnect the adapter from the outlet). Then contact the
nearest Minolta-authorized service facility for assistance.
CAUTION
Read through this manual before powering up this instrument for the first time.
The voltage/ampere rating of the AC adapter jack's is 9V DC / 300mA. The jack's outer
polarity is positive (+), and the inner polarity is negative (–). This instrument is designed
for use with the Minolta AC adapter AC-A10 (AC-A10N in North America) only. (The
adapter is sold separately.) Please do not use any other adapter with this instrument.

Connecting the AC Adapter

G Before unplugging the adapter, be sure to set the power switch back to OFF (" ").
1. Set the power switch to OFF (" ").
2. Connect the AC adapter to the AC adapter jack on the chroma
meter.
3. Plug the AC adapter's plug into an AC outlet.
23