Gigaset SL930A Manual page 95

"Base connection lost - Searching for base..." appears in the display.
u
The handset is outside the range of the base:
u
The base is not switched on:
u
The base's range is reduced because Maximum range is deactivated:
¤
Activate Maximum range ( page 39) or reduce the distance between the handset and
base.
"Handset is not registered to any base." appears in the display.
u
The handset has not yet been registered or was de-registered due to the registration of an
additional handset (more than six DECT registrations):
The handset does not ring.
u
None is set as the ringtone:
You cannot hear a ringtone/dial tone from the fixed line network.
u
The phone cable supplied has not been used or has been replaced by a new cable with the
wrong pin connections: Please always use the phone cable supplied or ensure that the pin
connections are correct when purchasing from a retailer ( page 99).
Forgotten system PIN.
¤
Reset the system PIN to 0000 ( page 43).
The other party cannot hear you.
u
The handset is "muted" Reactivate the microphone ( page 29).
The caller's number is not displayed.
u
Calling Line Identification (CLI) is not approved for the caller:
network provider to enable Calling Line Identification (CLI).
u
Caller display (CLIP) is not supported by the network provider or is not enabled for you:
Caller display (CLIP) must be enabled by the network provider.
u
Your telephone is connected via a PABX or a router with an integrated PABX (gateway) that
does not transmit all information:
¤
Reset the system: Briefly pull out the power plug. Reinsert the plug and wait until the
device restarts.
¤
Check the settings on the PABX and activate phone number display, if necessary. To do
this, search for terms such as CLIP, calling line identification, phone number identification,
caller ID, etc. in the system's user guide or ask the system manufacturer.
You hear an error tone when keying an input.
u
Action has failed/invalid input: Repeat the process. Read the display and refer to the user
guide if necessary.
You cannot listen to messages on the network mailbox.
u
Your PABX is set to pulse dialling:
You cannot connect to the internet.
u
WLAN is switched off:
u
No connection to the router or password/network name is wrong:
connection ( page 45).
Check the base power adapter ( page 7).
Select ringtone ( page 35).
Set your PABX to tone dialling ( page 91).
Switch on WLAN ( page 45).
Customer service & Help
Move the handset closer to the base.
Register the handset ( page 56).
The caller should ask the
Establish WLAN
93