Table of Contents
Advertisement
setup and connections
C
ONTENTS OF THE
Cinema Screen monitor
Power cord
Ferrite cores
RGB cable (Mini D-Sub 15-pin to Mini D-Sub 15- pin connector)
Remote control unit with two AA batteries
User's manual
It is highly recommended that you have your Cinema Screen monitor installed by a professional. If
you are installing the monitor yourself, refer to the Reference section.
NOTE: If you are planning on attaching the floor stand to your Cinema Screen monitor (and not the optional wall mount unit)
you may want to use the safety metal fittings (provided) to give your monitor extra stability.
The safety metal fittings attach to the back of the screen and can then be used to secure the monitor to the wall with strong wire.
Contact your trained, authorized Cinema Screen dealer for professional installation.
In order to conform to mandatory FCC standards, you must attach the supplied ferrite cores to both ends of the power cable
(see below).
If you are connecting a computer to the monitor, you must attach the ferrite cores to both ends of the DVI cable to meet
FCC standards.
A
TTACHING THE FERRITE CORES
Set the ferrite cores on the both ends of the DVI cable (not supplied), and one end of the power cable (supplied). Close the
lid tightly until the clamps click. Use the band to secure the ferrite core (supplied).
DVI cable
(not supplied)
power cable (supplied)
6
P
ACKAGE
band
core (small)
band
connector
core (small)
band
(monitor side)
core (large)
Advertisement
Table of Contents
