Table of Contents
Advertisement
Basic functions
Turning on the system:
"HELLO" will appear on the display
The message
Turning off in standby:
"GOODBYE"
will appear and the device will switch itself into standby mode.
Volume control
On the remote control:
On the main device:
If you choose the minimum volume, the display will show
MAX"
will briefly appear in the display.
To turn off the volume temporarily:
the display. When you press the button again, the volume is restored.
Adjusting the sound
You can raise or lower the bass and treble for your favourite music.
On the main device:
+8.
Equaliser
On the remote control:
JAZZ -> CLASSIC -> ROCK
Using the CD und USB functions
Preparation
Loading a CD
1.
Press the
button on the main device or remote to open the CD compartment
2.
Insert a CD with the printed side facing upwards in the CD compartment
3.
Press
the button on the main device or remote to close the CD compartment
Removing a CD
1.
Press the
button on the main device or remote to open the CD compartment
2.
Carefully remove the CD from the CD compartment
3.
Press
the button on the main device or remote to close the CD compartment
Connecting USB devices
1.
Press the
button to put the device in standby mode.
2.
Connect the USB device to the USB port on the rear of the device.
Disconnecting USB devices
1.
Press the
button to choose standby mode.
2.
Remove the USB device from the USB port.
Press the
Press the
button on the remote or on top of the device. The message
VOL+
Press the buttons
Press the volume control to increase and decrease the volume.
Press the
Press the BASS or TREBLE controls, to adjust the gain level in increments of 2 from -8 to
EQ
Press the
button to choose the following settings in sequence:
button on the remote or on top of the device.
.
to increase the volume and
"VOL MIN"
button on the remote control. "MUTE" will flash on
VOL-
to lower it.
and for maximum volume
POP -> FLAT ->
"VOL
9
Advertisement
Table of Contents
