Table of Contents
Advertisement
Deleting ALL Volume Punchthrough Commands
To delete all programmed Volume Punchthrough settings and return the remote control back to
the factory defaults, press and hold the VOL- button (the component button of the Volume
Punchthrough lights). While holding the VOL- button, enter the code, 000, using the number
buttons. All component buttons turn on for 2 seconds and then turn off. The remote returns to
the factory settings.
Note: If an invalid button is pressed, all component buttons blink 4 times and turn off. At
this point, you must start over.
Input source
Acquiring Channel...
Front Input
Listening to: English in SRS FOCUS
Note: Watch the Channel Banner to see the input sources change
each time you press the INPUT button.
Using the INPUT Button
1. Repeatedly press the INPUT button to scroll through the available input sources until you
find the input associated with the component (such as VCR or DVD player) you want to
view.
2. Once you find the input source you want, stop pressing INPUT.
•
If you tune to INPUT 1 and your VCR is connected to that input, you will be able to
view your VCR. To play, stop, or rewind the VCR tape using the remote that came with
your TV, you must first press the VCR, or AUX button (if AUX is programmed to VCR)
to put the remote control in VCR mode.
There are other ways of selecting a Video Input Channel:
•
Program the component (VCR, DVD, etc.) buttons on the remote control to automatically
tune to the correct Video Input Channel when pressed. For more details on Auto Tuning,
see Chapter 3.
•
When viewing an input, press ANTENNA, GO BACK, or INPUT to go back to viewing
channels or use the number buttons to enter the channel number.
Chapter 2
MPAA - Not Rated
Using the Remote Control
00:30
12:30 AM
4:3 Normal 480i SD
12:39 PM
DVD
37
Advertisement
Table of Contents
