Table of Contents
Advertisement
References
Accessory Information
The following accessories are available from most dealers and electronics supply stores in case
you want to position your components farther apart or need additional cables.
Monaural VCR Dubbing Audio/
Video Cable is a double cable
that lets you connect the video
and audio jacks of two VHS VCRs
to duplicate tapes. It can also be
used to connect a VCR to your
TV. The cable is color-coded and
shielded. It has RCA-type phono
plugs on each end. Gold-Tipped
cable, VH83 (6-ft)
Stereo VCR Dubbing Audio/
Video Cable is a triple cable that
lets you connect the
AUDIO
Gold-Tipped cable, VH84 (6-ft)
Push-on Cable* attaches to the
round antenna connectors (called
75-ohm F-type) on the back of
your VCR or TV. The ends push
on for a quick connection. VH89
(6-ft)
* This accessory is intended for use with an off-air or cable TV signal distribution and is not suitable for distribution of
the satellite signal originating from your satellite dish antenna.
84
and
VIDEO
jacks of stereo components.
Screw-on Cable* attaches to the round
antenna connectors (called 75-ohm F-
type) on the back of your VCR or TV.
The ends screw onto the connectors for
a secure connection. VH82 (6-ft), VH81
(3-ft)
S-Video Cable has multi-pin
connectors on each end for connecting
S-Video components to your TV. VH976
(6-ft), VH913 (12-ft)
RG-6 Coaxial Burial Cable with
weatherproof "F" connectors. D905
Optical/SPDIF cables help you
connect to a component with an Optical
Audio In jack, such as a Dolby Digital
decoder or receiver. DV3 (3-ft),
DV6 (6-ft)
Network Category 6 cables help you
connect to a component with an
ethernet jack. High performance
500MHz Bandwith, 5x bandwidth of
standard Category 5 cable TP603N (3-ft),
TP607N (6-ft), TP625N (25-ft)
Chapter 5
Advertisement
Table of Contents
