Fujitsu M3093DE Cleaning And Maintenance page 63

Activating the continuous operation test
Open the ADF and close it again. If no document is loaded on the ADF within five seconds after
closing the ADF, the image scanner runs in flatbed mode. If documents are loaded on the ADF
within five seconds after closing the ADF, the image scanner continuously feeds the document
from ADF. Once the image scanner starts reading documents in flatbed mode, it does not feed
documents from ADF even if documents are loaded on the ADF.
Ending the test in flatbed mode
To stop the carrier movement in flatbed mode, open the ADF. If the ADF is opened, the POWER
lamp starts blinking immediately after the carrier returns to the home position.
Ending the test in ADF mode
If the ADF hopper is empty, feeding documents from the ADF ends. To restart feeding, open the
ADF and close it again. Then load documents on the ADF paper chute within five seconds after
closing the ADF.
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
LED status on error
If an error occurs during the test, the LED indicates as shown in the following table.
Errors
Status
LED
indicates
Power
Read
Check
N O T E
5-18
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Paper Carrier
jam unit
error
Blink On
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Front Back
optical optical
system system
error error
Off
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Motor
fuse
failure
○ ○ ○ ○ ○ ○ ○
Lamp
fuse
failure