Step 3: Place Batteries In The Remote Control; Step 4: Plug In And Turn On The System; Step 5: Complete The Interactive Setup; Step 6: Order Programming - RCA F38310 User Manual

Setup and Connections
Step 3: Place Batteries in the
Remote Control
Follow these steps whenever you need to install or change the batteries
in your TV's remote control.
1. Remove the cover from the battery compartment.
2. Insert batteries into the battery compartment, matching
the + and – end of each battery.
3. Replace the cover.
Step 4: Plug in and Turn on the
System
Plug one end of the power cord into the back of the television as shown
on right. Plug the other end into a wall outlet. Be sure to insert the
plugs completely.
To turn on the TV, press the TV or ON•OFF button on the remote control
or the POWER button on the front panel. It may take several seconds for
the TV to turn on.
Step 5: Complete the Interactive
Setup
Interactive setup appears when you turn on your TV for the first time.
Follow the steps to configure the basics of your system, such as setting
up the time and day, searching for available channels, and setting up
speakers. To run it again, select Assistance from the main menu, then
select Interactive Setup. For more details, see the section "Getting
Assistance" in this book.

Step 6: Order Programming

You should decide if you would like to receive DIRECTV
To receive DIRECTV programming, your satellite dish antenna must be
installed and pointed correctly. You must also contact your service
provider, DIRECTV.
Programming with DIRECTV:
* Receipt of DIRECTV programming is subject to the terms of the DIRECTV
Customer Agreement, a copy is provided with your first billing statement.
DIRECTV is a trademark of DIRECTV, Inc., a unit of Hughes Electronics Corp., and is
used with permission.
1 6
® programming*.
Call 1-800-347-3288
When you order programming, you need
to know your access card number. To get
the number, select Assistance from the
main menu and then select System Test.
Wait for the system to run all of its tests.
The access card number is displayed at the
end of the system test.
Write the access card number in the space
below for easy reference:
______________________________
POWER
TV