Advertisement
Firmware Update Through the Internet
Requirement:
Internet connection
Your receiver is connected to the Internet if you can receive Internet radio stations.
(See owner's manual for details)
1
Power off the receiver (Standby mode)
2
Enter the ADVANCED SETUP mode
While pressing the STRAIGHT key, press the MAIN ZONE
"
ADVANCED SETUP
"
ADVANCED SETUP
*
Select "FIRM UPDATE" from the menu
3
a. Press the PROGRAM key until "
b. Then, press STRAIGHT key until "
4
Start firmware update
a. Press INFO (WPS) key to start the update.
(Update process may take up to 15 minutes)
If "
UPDATE SUCCESS
*
exit from Advanced Setup. Your AV receiver is ready for normal use.
Caution
DO NOT interrupt power during the update.
In case the power is accidentally cut off resulting in a condition where you can't recover normal operation, refer to
the troubleshooting method (Troubleshooting CASE 2) on the last page.
b. When completed, "
c. Turn off the power of the receiver by pressing the MAIN ZONE
MAIN ZONE key
PROGRAM key
" appears on the front panel display.
" is displayed only for a few seconds.
FIRM UPDATE USB
NETWORK
" appears, this means your receiver is already up-to-date. In this case, power off to
Firmware update in progress
" , "
UPDATE SUCCESS
STRAIGHT key
key and keep STRAIGHT key pressed until
" is displayed.
" is displayed.
" and "
PLEASE...
POWER OFF!
key.
INFO (WPS) key
" appears on the display.
(The design may differ by models.)
2
Advertisement
