Advertisement
XA-120IP
Installation
Before installation
• Choose the installation location carefully so that the unit
• Choisissez soigneusement l'emplacement de sorte
does not interfere with normal driving operations.
• Avoid installing the unit in areas subject to:
— high temperatures, such as from direct sunlight or
• Évitez d'installer l'appareil dans des endroits soumis :
hot air from the heater.
— draft, rain or moisture.
— dust or dirt.
— magnetic fi elds.
• Use only the supplied mounting hardware for a safe and
secure installation.
• Pour garantir un montage sûr et fi able, n'utilisez que le
If you have any questions or problems concerning your
unit that are not covered in this manual, please consult
Si vous avez des questions ou des problèmes concernant
your nearest Sony dealer.
votre appareil qui ne sont pas abordés dans ce mode
d'emploi, contactez votre détaillant Sony le plus proche.
Parts list/Liste des pièces/Lista de las piezas
Mounting example/Exemple de montage/Ejemplo de montaje
Connection example/Exemple de raccordement/Ejemplo de conexión
A
iPod
BUS AUDIO IN
XA-120IP
BUS CONTROL IN
Connection diagram/Schéma de raccordement/Diagrama de conexión
Sony BUS compatible car audio unit
Autoradio compatible BUS Sony
Unidad de audio para automóvil compatible
con el sistema BUS de Sony
BUS AUDIO IN
SECTION 1
Installation
Instalación
Avant l'installation
Antes de realizar la instalación
• Elija cuidadosamente la ubicación de instalación de
que l'appareil ne gêne pas les opérations de conduite
modo que la unidad no interfi era en las operaciones
normales.
normales de conducción.
• Evite colocar la unidad en lugares expuestos a:
— à des températures élevées, comme à la lumière
— altas temperaturas, como a la luz solar directa o al
directe du soleil ou à l'air chaud d'un radiateur ;
— aux courants d'air, à la pluie ou à l'humidité ;
— corrientes de aire, lluvia o humedad.
— à la poussière ou à la saleté ;
— polvo o suciedad.
— à des champs magnétiques.
— campos magnéticos.
• Utilice únicamente la ferretería de montaje suministrada
matériel fourni.
para garantizar una instalación segura y sin peligro.
Si desea realizar alguna consulta o solucionar algún
problema relativos a la unidad que no se traten en este
manual, póngase en contacto con el distribuidor Sony más
cercano.
(×2)
Make sure that the iPod is placed where driving is
not obstructed, such as the glove box of the car, etc.
Assurez-vous que l'iPod est placé à un endroit qui
ne gêne pas la conduite tel que la boîte à gants de
la voiture, etc.
Asegúrese de que el iPod está colocado en un
lugar en que no difi culte la conducción como, por
ejemplo, en la guantera del vehículo, etc.
B
Source selector
XA-C40
BUS AUDIO IN
(not supplied)
Sélecteur de source
XA-C40
(non fourni)
Selector de fuente
XA-C40
BUS CONTROL IN
(no suministrado)
1
*
You cannot connect two or more satellite radio
tuners (XM/SIRIUS) to XA-C40 at the same time.
When you use a satellite radio tuner, be sure to
connect to the INPUT 1 terminal of XA-C40.
2
*
Only one iPod can be used with the source selector.
*
1
Vous ne pouvez pas raccorder plusieurs syntoniseur
radio satellite (XM/SIRIUS) au XA-C40 en même
temps.
Lorsque vous utilisez un syntoniseur radio satellite,
veillez à le raccorder à la borne INPUT 1 du XA-C40.
*
2
Il n'est possible d'utiliser qu'un seul iPod avec le
sélecteur de source.
2m
2m
L
R
BUS
AUDIO
IN
BUS
CONTROL IN
GENERAL
aire caliente de la calefacción.
INPUT 1
Satellite radio tuner
(XM/SIRIUS)*
1
Syntoniseur radio satellite
(XM/SIRIUS)*
1
Sintonizador de radio vía satélite
(XM/SIRIUS)*
1
INPUT 2
iPod
CD/MD changer
Changeur de CD/MD
Cambiador de CD/MD
INPUT 3
XA-120IP
*
2
1
*
No es posible conectar más de un sintonizador de
radio vía satélite (XM/SIRIUS) al modelo XA-C40
simultáneamente.
Cuando utilice un sintonizador de radio vía satélite,
asegúrese de conectarlo al terminal INPUT 1 del
XA-C40.
2
Sólo se puede utilizar un iPod con el selector de
*
fuente.
iPod
1m
This section is extracted
from instruction manual.
Operation
• The display and function buttons differs depending on the car audio unit that
controls the iPod.
• When the iPod is connected to the adaptor, operation from it cannot be performed;
operate the iPod from your car audio unit.
• Before connecting the iPod to the adaptor, turn down the volume of the car audio unit.
Playing tracks
1
Connect the iPod to the adaptor.
The iPod will turn on automatically, and the display as below will appear on the iPod screen.
2
Press
to select the iPod.
"PD1" or "Portable" appears in the display of a car audio unit, and the tracks on the iPod start
playing automatically from the point last played.
Note
If the iPod is not connected, "No iPod" will be displayed in the display of the car audio unit.
3
Press
to select the play mode.
The mode changes as follows:
Resuming
Album
Artist
Playlist
4
Adjust the volume.
To
Press
Stop playback
Pause tracks
(PAUSE)
Resume play after pause
(PAUSE)
Skip tracks
/
(SEEK +/−)
[once for each track]
Skip tracks continuously
/
(SEEK +/−)
[
press, then press again within about 2 seconds and hold
Fast-forward/reverse
/
(SEEK +/−)
[hold to desired point]
Tips
• The iPod can be connected to or disconnected from the dock connector either during playback or pause.
• When the ignition key is turned to the ACC position, or the car audio unit is on, the iPod will be recharged.
• If the iPod is connected while playing a track, the track will continue to play after the connection. If the iPod is
disconnected during playback, playback will pause.
• When the iPod is connected to the dock connector, the mode changes to the Resuming mode. In Resuming mode,
pressing the Repeat, Shuffl e or Scan button does not function. If you cancel Resuming mode by pressing
or GP/ALBM +/–, the Repeat, Shuffl e or Scan buttons now function to change the play mode.
Notes
• To turn the iPod off, either disconnect it from the adaptor, or turn the ignition key to the OFF or ACC position.
The iPod will turn off after approx. 2 minutes.
• If "No iPod" appears while connecting the iPod to the dock connector, disconnect the iPod from the dock connector,
then reconnect.
Changing the display items
1
During playback, press
.
The display items changes as follows:
Track name
Track number
Elapsed playing time
Album name
Notes
• If the name of a track, album, artist or playlist is not entered on the iPod, "No name" will appear in the display of
a car audio unit.
• If the car audio unit has a separate display for the clock, the current time will not appear in the display of the car
audio unit even by pressing
.
• Some letters stored in iPod may not be displayed correctly on the connected car audio unit.
Setting the play mode
Selecting Album, Artist or Playlist
You can select an Album, Artist or Playlist, and
playback starts
.
1
During playback, press
.
The mode changes as follows:
Album
Artist
Playlist
Skipping albums, artists and playlists
To
Press
Skip
GP/ALBM +/−
[press once for each]
Skip continuously
GP/ALBM +/−
[hold to desired point]
Repeat Play
You can select to play tracks on the iPod
repeatedly
.
1
During playback, press
until the desired setting appears.
Select
To play
Repeat track
track repeatedly
Repeat album
album repeatedly
Repeat artist
artist repeatedly
Repeat playlist
playlist repeatedly
Repeat play starts.
To return to normal play mode, select "Repeat off."
Shuffl e Play
You can select to play tracks on the iPod in random order.
1
During playback, press
until the desired setting appears.
Select
To play
Shuffl e album
album in random order
Shuffl e artist
artist in random order
Shuffl e playlist
playlist in random order
Shuffl e all
all tracks in random order
Shuffl e play starts.
To return to normal play mode, select "Shuffl e off."
Note
GP/ALBM +/− button will not work during shuffl e play.
Scan
You can quickly locate a specifi c point on the iPod.
1
During playback, press
(BBE MP) until
"Scan on" appears.
The fi rst 10 seconds of each track will be played.
To return to normal play mode, select "Scan off."
Note
This function will not work during shuffl e play.
]
Artist name
(Clock)
Advertisement
