Broan QML Series Instructions Manual page 4

CONTENTS
(1) G F
REASE ILTER
(1) P
ARTS
(5) N . 10 5/8"
O X
RD. HD.
M S
OUNTING CREWS
PREPARE THE HOOD
7 Remove all
protective polyfilm
from the hood
(stainless steel
hood only).
8 Remove the
Aluminum Filter
from the hood by
pulling the tab
down and lifting
filter out.
(4)
9 Remove 8 Screws holding Bottom Panel to hood.
Disconnect Lamp wire harness.
10 Remove parts bag included with the hood. (Parts bag is
taped to inside of bottom panel.)
SCREWS
DAMPER
ASSEMBLY
11 Remove 2 Screws holding Damper Assembly to hood.
Remove damper assembly from inside the hood.
* F
IND INSIDE
OF HOOD
(1) 3¼" 10" (1) 7" R
X
D D C
AMPER UCT
*
ASSEMBLY
B ** C :
AG ONTAINING
(1) B S
ULB UCTION
C T
UP OOL
** F
IND PARTS BAG TAPED TO
INSIDE OF BOTTOM PANEL
(1)
PULL
ALUMINUM
DOWN
(2)
FILTER
LIFT
OUT
(4)
OUND
ONNECTOR
12 Remove 7" Round Duct Plate from top/back of hood.
FOR NON-DUCTED INSTALLATIONS - Skip to "INSTALL
THE HOOD" .
BAFFLE
13 DUCTED INSTALLATION ONLY:
Remove Baffle from Slot above air box.
BAFFLE
14 DUCTED INSTALLATION ONLY:
Rotate Baffle and insert long side into Slot above air box.
Baffle is inserted properly when you feel a positive stop.
15 NON-DUCTED INSTALLATION ONLY:
Purchase a non-ducted filter (Model BPQTF) from your local
distributor or retailer. Attach the non-ducted filter following
instructions packed with the non-ducted filter.
QML SERIES
7" ROUND
DUCT
PLATE
SLOT
SLOT
Page 4