Operation - SEVERIN AH7914 Instructions For Use Manual

First insert the charging plug into the wall
bracket, facing up.
Mount the wall bracket vertically, near a wall
socket, using the screws provided with the
appliance.
Both the crevice tool with brush and the
rubber nozzle can be stored on the left and
right sides of the appliance.
Connecting the rechargeable battery
The battery compartment is located on
the underside of the appliance. Open the
compartment by removing the screw in
the compartment cover using a suitable
screwdriver. Lift out the battery pack and
push together the two connectors on the
wires from the main unit and the battery;
make sure the catch locks over the stop.
Place the battery in the appliance and fi t the
connectors alongside the battery. Replace
the battery compartment cover and tighten
the screw.
Charging process
Before using the vacuum cleaner for the
fi rst time, the battery must be charged for a
period of approximately 10 hours.
∙ Insert the adaptor into a wall socket.
∙ Put the On/Off switch to its off position.
∙ Place the vacuum cleaner in the wall
bracket. The charging process begins
automatically and the indicator light
shows red. Once the red indicator light
goes out, the appliance is ready for use.
∙ This appliance can remain on charge
indefi nitely without damage or danger
and is therefore fully charged and ready
for use at all times.
∙ Whilst charging, the adaptor will become
warm. This is perfectly normal and safe
and does not indicate a malfunction of
any kind.
∙ If the vacuum cleaner is not being used
for a long period of time, the capacity of
the battery may decrease by a certain
amount. However, full capacity will be
restored after several charge/discharge
cycles.
12 V operation
∙ With the 12 V connector, the battery
pack may be recharged through the car
cigarette-lighter socket.
∙ Insert the small plug of the connecting
cable into the 12V jack of the vacuum
cleaner, and the larger plug into the car's
cigarette-lighter socket.
∙ Power is now supplied directly from the
car's electrical system; the indicator lamp
shows red.
Picking up liquid matter
Before picking up liquid matter, ensure that
the rubber nozzle is fully inserted in the
suction aperture.
Crevice tool
The crevice tool can be inserted into the
suction aperture to clean crevices, corners
and other areas diffi cult to reach.
Crevice brush
The crevice brush can be fi tted to the crevice
tool and is suitable for cleaning uneven
surfaces such as computer keyboards etc.

Operation

∙ Remove the vacuum cleaner from its wall
bracket.
∙ If required, fi t any of the nozzle
attachments to the suction aperture.
∙ Switch on the appliance using the On/Off
11