Important Information - Gazer F117 User Manual

ENG
ENG
•
Do not insert or remove the SD card when the device is on. This
can lead to the MVR malfunction. Wait for 30 seconds after MVR
shutdown, make sure that all the lights are off for at least 10
seconds, and only then safely remove the memory card.
•
Set the correct time and date before using the device.
•
Use at least 0.5 seconds time interval while pressing control
buttons, this guarantees proper functioning of the device.
•
Carefully connect the power supply cable to the device. MVR
power supply cable should not be confused with the radar
detector or navigator power supply cables (those may have
voltage of +12V). A wrong connection may cause MVR failure.
•
Do not turn off the power for at least 20 seconds after the power
supply cable is connected. This is necessary to help the built-in
battery function correctly.
•
If after you have started the car (when the power supply cable
is connected to the MVR), the device failed to switch to the
recording mode automatically, simply unplug the power supply
cable for ten seconds and then try again.
•
Use the restart option (by pressing RESET button) in the
following cases:
• power indicator is not on when the power supply cable is
connected;
• the device does not switch from the standby to the recording
or control mode;
• the device fails to function properly.
•
Files protected from overwriting by G-sensor or by pressing a
corresponding button are recorded in a loop with a 30% limit
of amount on the memory card. Check the free space left on
your memory card on a regular basis to prevent data loss (this
happens when the memory card is full).
6

Important information

Warning!