Table of Contents
Advertisement
Assembly Steps
4
● Fit the gear box onto the rear axle from the right side.(Face the rear of the vehicle)
● Fit the driving wheel onto the rear axle, the driving wheel should match with the gear box.
● Fit a Ø12 outer bush onto the rear axle, the outer bush should match with the driving wheel.
● Fit a wheel cover onto the rear axle.
● Fit a Ø12 washer onto the rear axle.
● Fit a Ø10 locknut to the end of the rear axle and tighten with the spanner. DO NOT over-tighten.
● Insert the tabs on the cap nut into the slots in the wheel cover and make it click into place.
● Fit the gear box onto the rear axle, make the motor on the gear box pass through the hole in the vehicle
body wall.(NOTE: "R" labeled gear box should be fit to the "R" side of vehicle body; "L" labeled gear box
should be fit to the "L" side of vehicle body)
● Fit the driving wheel onto the rear axle, the driving wheel should match with the gear box.
● Fit a Ø12 outer bush onto the rear axle, the outer bush should match with the driving wheel.
● Fit a wheel cover onto the rear axle.
● Fit a Ø12 washer onto the rear axle.
● Fit a Ø10 locknut onto the end of the rear axle and tighten with the spanner. (DO NOT over-tighten)
● Insert the tabs on the cap nut into the slots in the wheel cover and make it click into place.
● Repeat for the other driving wheel.
Gear box
Rear axle
Driving wheel
Wheel cover
Ø12 outer bush
Ø10 locknut
Cap nut
Ø12 washer
2WD
Advertisement
Table of Contents
