Actionbikes A30 Owner's Manual page 10

Assembly Steps
5
● Remove all the parts from the front axle.
● Fit a Ø12 washer onto the front axle.
● Fit a Ø12 inner bush onto the front axle.
● Fit a wheel onto the front axle and keep the inner bush match with the wheel.
● Fit a Ø12 outer bush onto the front axle and keep it match with the wheel.
● Fit the wheel cover onto the front axle.
● Fit a Ø10 locknut to the end of the front axle and tighten with the spanner. (DO NOT over-tighten, keep the
wheel can run smoothly)
● Insert the tabs on the cap nut into the slots in the wheel cover and make it click into place.
● Repeat for the other two wheel(s).
GAP
Wheel
Ø12 washer
Front axle
Ø12 inner bush
IMPORTANT SUPPLEMENT TO INSTRUCTION MANUAL
After assembling any wheel to the axles, please check the gap between the
screw thread and the collapsible (refer to below picture), if the gap is too big, please
add two or three washers inside the wheel, But after tightening the nut outside the
wheel, please turn the wheel by your finger to check if the wheel can run smoothly,
this is very important, because if the wheel can run smoothly, it is ok, but if the nut
press the wheel and the wheel can't run smoothly, the motor will be broken easily!
Then you need to decrease one or two washers to make sure the wheel can run
smoothly!
Wheel cover
Ø12 outer bush Ø12 washer
Ø10 locknut
Cap nut