Table of Contents
Advertisement
Assembly Steps
10
Ø4x16 screws
11
10-1
● Plug the motor connector(s) into the vehicle connector(s) under the seat.(image 10-1)
Ø4x16 round head
● Remove
● Fit the seat against the vehicle and tighten the screws with a screwdriver.
● Plug the power connector into the terminal on battery under the bonnet.(image 10-2)
● Close the bonnet.
Searching
lights
Light bar
screws in the vehicle with a screwdriver.
● Inset the tabs on searching light into the
hole in the light bar, and push until you hear it
click into place.
● Repeat for the other searching light.
● Fit and hold the light bar assembly against
the vehicle body, insert four Ø4x16 screws
through the light bar assembly and into the
vehicle. Tighten the screws with a
screwdriver.
Ø4x16 screws
(round head)
Seat
Power
connector
Battery
10-2
Advertisement
Table of Contents
