The GemOro PRO-M 3 is the ultimate READ BEFORE USING tester for diamond fraud protection! The PRO-M 3 features exclusive UV- A high percentage of the F1 TECHNOLOGY™ and is capable of new generation, super-low identifying the widest range of the electrically conductive Forever One or “F1”...
3. No warranties exist with respect conduct electricity. If a stone does to the PRO-M 3 or its use other than not conduct heat or electricity, it will those expressly contained herein. be determined to be more than likely...
Page 4
PRO-M 3 and for the tester may be used as desired convenience it should be used to while powered by the AC current. wipe any hand or body oil from the stones surface prior to testing.
Page 5
10 minutes of non-use. After batteries and conveniently powering down, if you wish to charged by a micro-USB adapter. resume using the PRO-M 3, simply The rechargeable batteries touch the tester’s power button may be substituted with AAA and within seconds the tester alkaline batteries if a suitable will turn itself back on again.
65°F-80°F (18°C-27°C). • Air Relative Humidity: 45%-75%. • Net Weight: Approximately 100g (including batteries). CAUTION DO NOT disassemble the PRO-M 3 other than to replace the batteries METAL ALERT or the warranty will become void. 13. LED Indicator. The round LED...
6. Prior to using the PRO-M 3, be of the tester and hold it down certain to REMOVE THE WHITE for approximately one second, CAP at the front end of the then release the button. There tester that serves to protect is no warm-up time required.
Page 9
You may also attach the optional GemOro Test Stone Magnifier (Item# 0780) to the PRO-M 3 by clipping it onto the end of the tester’s probe tip cone. This will allow you to see a magnified view of...
Page 10
Plug the adapter into a TO TEST LOOSE STONES convenient wall outlet. You may WHILE HOLDING THEM IN now simply place the PRO-M 3 in YOUR FINGERS OR THE TESTER the charging stations cradle with MAY NOT TEST CORRECTLY.
AAA alkaline batteries. replacement, probe tip cleaning, and recalibration. If service is 2. The PRO-M 3 is designed to be required, please contact your able to easily test faceted or supplier or the factory. Any other rough stones of virtually all sizes.
In the event the PRO-M 3 is no longer available or has been discontinued and warranty coverage is applicable, at the factory’s sole discretion, an equivalent tester may be substituted for the defective PRO-M 3.
Need help?
Do you have a question about the PRO-M 3 and is the answer not in the manual?
Questions and answers