General Specifications - QUALITY LIFTS Q10 Installation, Operation & Maintenance Manual

G S
ENERAL PECIFICATIONS
See Figure 1
A Rise Height (Screw Pads Highest Position)
B Overall Height (Adjustable)
C Overall Width
D Drive-Thru Clearance
E Floor to Overhead Switch
F Short Arm Reach
G Long Arm Reach
H Screw Pad Height
K Inside of Columns
Lifting Capacity *
Ceiling Height Required
Motor
Voltage
Speed of Rise **
Max Load Per Arm
* Lift capacity ratings are based on loads equally distributed on all four arms.
** Lifting and lowering speeds may vary depending on the weight of the vehicle.
Fig 1a - General Specifications
Model Q10
Installation, Operation and Maintenance
Page 2
Q10
78 3/4" (2000mm)
147 1/2" (3748mm) / 137 1/2" (3494mm)
131 3/4" (3347mm)
98 3/8" (2499mm)
140 1/2" (3568mm)/ 130 1/2" (3314mm)
21 3/4"-39 1/4" (553mm-998mm)
38 1/4"-55 3/8" (971mm-1407mm)
4 1/4"-7 3/4" (109mm-199mm)
110 1/4" (2800mm)
10,000 lbs. (4536 kg)
149" (3785mm)
2HP, Single Phase, 60Hz
208-230
52 seconds
2500 lbs (1134 kg)
Fig1b - Service Bay Lay
out
Rev. 10/22/08
Q10-IOM-Q
.doc