Grinder Assembly - Weston 82-0103-W Instructions Manual

GRINDER ASSEMBLY

WARNING! Before cleaning, assembling or disassembling the Grinder, make sure
it is turned "off" and disconnected from the power source. Test to make sure there is
no power to the Grinder by switching the Motor Unit "on" and "off."
1. Place the Plastic Washer then the Bushing Set onto the end of the Auger
opposite the Pin (FIGURE 1).
2. Carefully insert the Auger into the Grinder Head.
3. Place the Knife onto the square portion of the Auger Pin. The cutting edges of
the Knife should face outward (FIGURE 2).
4. Place a Grinder Plate onto the round portion of the Auger Pin. Align the tabs on
the Grinder Plate with the notches in the Grinder Head.
5. Screw the Front Ring Nut onto the Grinder Head until it is firmly tight. DO NOT
over-tighten the Front Ring Nut to avoid damaging the Grinder during operation.
6. Loosen the Head Locking Knob on the side of the Motor Unit.
7. Install the Grinder Head onto the Motor Unit (FIGURE 1).
8. Tighten the Head Locking Knob to secure the Grinder Head.
9. Install the Tray onto the Grinder Head. Press the Tray down until fully seated (FIGURE
1).
FIGURE 2
Knife
with
cutting
edges
facing
outward.
Front
Grinding
Ring
Plate
Nut
Auger
Auger
Pin
Grinder
Plastic Bushing
Washer Set
Tray
Head
Stomper
FIGURE 1
Head
Locking
Knob
Motor
Unit
Power
Switch
Reverse
Button
7