Winnebago Suncruiser 1999 Owner's Manual page 87

mode. The mode provides refrigeration until the
refrigerator is serviced. Monitor the refrigerator
and freezer temperatures when operating in this
mode. If the refrigerator temperature is too cold,
adjust the thermostat to the left in single LED
increments. If the refrigerator temperature is too
warm, adjust the thermostat to the right in single
LED increments. Allow the refrigerator to oper-
ate at the new setting for one hour before
rechecking the temperatures (frequent door
opening prevents the temperature from stabiliz-
ing). Although the refrigerator can operate in
this mode, Norcold recommends that you seek
service as soon as practical to restore normal
operation.
OPERATING INSTRUCTIONS
Optional Norcold 900-Series Models with
Electronic Auto Mode Control
Start-Up Instructions - Gas Mode
The control panel is located between the
freezer compartment and fresh food compart-
ment. It contains pressure sensitive touch
switches and LED display. The AC, LP GAS,
Battery, and AUTO LED's (A) illuminate to
indicate the refrigerator's operating mode.
The ON/OFF button (E) turns the refrigera-
tor On or Off. If the button is pressed, it will turn
the refrigerator On and set the mode to AUTO.
When the refrigerator is On, pressing this button
for 2 seconds will turn the refrigerator Off.
Pressing and holding the MODE button (C)
allows the user to cycle through the three mode
choices; one AUTO and two manual modes
(AC, LP GAS). The refrigerator will not switch
to the new operating mode until the mode button
is released.
The TEMP SET (thermostat) button (D) con-
trols the refrigerator and freezer temperature
during both gas and electric operation. Press and
hold the TEMP SET button to select the desired
APPLIANCES & INTERIOR FEATURES
temperature setting. The temperature settings are
shown in the form of LED's (A). The illumi-
nated LED indicates the temperature setting,
with COLD on the left and COLDEST on the
right. The temperature LED turns off after 10
seconds. Quickly press and release tempset but-
ton to display the temperature setting.
Start-Up Instructions - Auto Mode
When the AUTO mode is selected, the oper-
ating control automatically selects the power
source using the following priority scheme:
• When 120 volts AC is available to the refrig-
erator, the AUTO LED and the AC LED will
illuminate, indicating the refrigerator is oper-
ating on AC electric.After 10 seconds, the
AC LED will turn off and only the AUTO
LED will remain illuminated. Press and
quickly release mode button to display the
operating mode.
• If 120 volts AC is not available, the refriger-
ator will switch to the gas operation. The
AUTO LED and the LP GAS LED will illu-
minate. After 10 seconds, the LP GAS LED
will turn off and only the AUTO LED will
remain illuminated. Press and quickly
release mode button to display the operating
mode.
During operation in the AUTO mode, when
a higher priority power source becomes avail-
able, the operating controls will cease using the
current power source and will switch to the
higher priority power source. For example, if
AC electric becomes available while the refrig-
erator is operating in the AUTO LP GAS mode,
the refrigerator will switch to AUTO AC opera-
tion.
If an operating mode is not functional, its
corresponding LED will flash and the refrigera-
tor will attempt to operate in a lower power pri-
ority source. If a lower power priority source is
not available, the LED will continue to flash,
and the refrigerator will cease operation until the
energy source is corrected. Refer to the "Diag-
nostic" section on page 7 of the "Norcold 9100
Series Refrigerators Operator's Guide" in your
blue binder.
SECTION 8
8-3