Driving Your Motor Home - Winnebago Suncruiser 1999 Owner's Manual

Table of Contents

Advertisement

LEVELING:
1. Shift transmission into Park and set the Park
Brake. Turn the ignition key to the ACC
position.
NOTE: The 'NOT IN PARK/BRAKE' light
will glow if the park brake has not been set.
2. Press the system ON button to turn the sys-
tem on. The indicator light above the switch
will glow.
Power On
Indicator Light
"On"
Button
"Off" Button
3. Move the front and rear Jack Levers outward
to the operating positions. Nothing should
happen yet at this time.
HWH HYDRAULIC LEVELING
FRONT
RAISE
LEFT
RIGHT
RAISE
RAISE
Jack
REAR
Lever
RAISE
in
Operate
Position
"CAUTION"
UNDERSTAND OPERATOR'S MANUAL BEFORE USING
BLOCK FRAME AND TIRES SECURELY BEFORE
REMOVING TIRES OR CRAWLING UNDER VEHICLE
4. Extend the hydraulic jacks by pushing the
center Control Lever to Front Raise, then
Rear Raise. A corresponding, red warning
light will glow as each jack is in position.
5. Check that all jacks have extended. Place
pads under jacks at this time, if necessary.
6. A lit yellow light indicates that end or side of
the coach is low. Move the Control Lever to
Red Warning Lights
Indicate When A
Jack is Vertical
or Extended
Yellow Level
Indicator Lights
(Indicates Which
Side or End is
Low - All Off
When Vehicle is
Level)
Control Circuit Fuse
(5 Amp)
OPERATE
Control
Level
STORE
FRONT
STORE
REAR
OPERATE

DRIVING YOUR MOTOR HOME

the Raise position of the corresponding side
or end until all yellow lights are out. If the
ground is too uneven, the jacks may not have
enough stroke to level the coach. The coach
may have to be moved to a different spot.
Remember: If the rear of the coach is lifted
too high, the coach may roll forward or back-
ward off the jacks.
7. After the coach is level, the jacks not
extended fully for leveling may be extended
until they touch the ground. This keeps the
coach stable against winds or activity in the
coach. Do not use the right or left extend
positions.
8. Press the OFF button on the system panel
and turn the ignition switch OFF.
TO RETRACT JACKS AND PREPARE
FOR TRAVEL:
1. Be sure there are no objects under the coach
and all people are clear of the coach.
2. Turn ignition switch to ON or ACC and
press the system ON button.
3. Move the Jack Levers to the storage/travel
position. This will allow the jacks to retract.
HWH HYDRAULIC LEVELING
FRONT
RAISE
LEFT
RIGHT
RAISE
RAISE
REAR
RAISE
Jack
Lever
in
Store
Position
"CAUTION"
UNDERSTAND OPERATOR'S MANUAL BEFORE USING
BLOCK FRAME AND TIRES SECURELY BEFORE
REMOVING TIRES OR CRAWLING UNDER VEHICLE
4. Check the warning lights on the system
panel and the Jacks Down light. All warning
lights should now be off.
5. Press the OFF button on the system panel
and turn the ignition switch off.
6. The coach may now be moved.
7. If jacks do not retract and system does not
shut off as described, see Troubleshooting
instructions in the manufacturer's operating
guide included in the Owner InfoCase.
SECTION 2
OPERATE
STORE
FRONT
Control
Lever
STORE
REAR
OPERATE
2-17

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents