Installer Setup; Advanced Settings - Honeywell VisionPRO TB8220 User Manual

TB8220 COMMERCIAL VISIONPRO™ PROGRAMMABLE THERMOSTAT

INSTALLER SETUP

Advanced Settings

The thermostat has advanced settings to match the HVAC
system. These settings can be adjusted to match specific
needs.
Installer Settings (Complete Set)
Access to the installer settings is obtained as follows:
1. From the main screen, press SYSTEM. Five blank touch
keys show on the bottom of the screen between DONE
and CANCEL.
2. Press and hold the two blank keys on either side of the
center blank key for approximately five seconds. (See
Fig. 32.)
3. The Setup Number displays to the lower-left area of the
screen. It is a four-digit code beginning with zero. The
current setting is displayed to the right.
NOTE: To cycle through the Setup Numbers, press the up or
down arrow.
MO TU WE
Inside
SYSTE
M
EM
HEAT
OFF
DONE
Fig. 32. Entering Installer Setup.
63-2625—3
TH FR SA SU
Set To
Following
Schedule
CANC
M19923
There are two different groups of settings:
— A complete set designed for the installation use.
— A simple set to limit accessibility for typical users.
User Settings (Simple Set)
Access to the user settings is obtained as follows:
1. From the main screen, press SYSTEM. Five blank touch
keys show on the bottom of the screen between DONE
and CANCEL.
2. Press and hold the center blank key approximately five
seconds.
3. The Setup Number displays to the lower-left area of the
screen. It is a four-digit code beginning with zero. The
current setting is displayed to the right.
NOTE: To cycle through the Setup Numbers, press the up or
down arrow.
SYSTEM
OFF
COOL
DONE
Fig. 33. Entering User Setup.
12
TUE
CHANGE FILTER UV LAMP
Inside
Following
Schedule
PM
CANCEL
M22766