Maintenance; Protecting The Environment; Using The Led Area Light - Black & Decker BDJS350 Manual

11. Carefully press the negative (black) jumper cable wire
into the storage channel starting at the end furthest from
the clamp.
12. Clamp the negative (black) clamp onto the clamp
holder (12).
13. Carefully press the positive (red) jumper cable wire into
the storage channel starting at the end furthest from the
clamp.
14. Clamp the positive (red) clamp onto the clamp
holder (12).
15. Charge the unit as soon as possible.
Note: After each use, clean the battery clamps (2) and be
sure to remove any battery fluid that will cause corrosion of
the clamps (2). Keep the battery charger cords loosely coiled
during storage to prevent damage to the cords.
Using the LED area light (fig. A)
The LED area light (1) will operate up to 50 hours on a full
charge. The LED area light's operating life is 100,000 hours.
Press the LED area light on/off button (3) on the top
panel of the unit to turn the LED area light (1) on.
Press the LED area light on/off button (3) again to turn
the LED area light (1) off.
Make sure that the LED area light is turned off while the unit
is being charged or stored.

Maintenance

Your Black & Decker corded/cordless appliance/tool has
been designed to operate over a long period of time with a
minimum of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
Warning! Before performing any maintenance on corded/
cordless power tools:
Switch off and unplug the appliance/tool
Or switch off and remove the battery from the appliance/
tool if the appliance/tool has a separate battery pack
Or run the battery down completely if it is integral and
then switch off
Unplug the charger before cleaning it. Your charger
does not require any maintenance apart from regular
cleaning.
Regularly clean the ventilation slots in you appliance/tool/
charger using a soft brush or dry cloth.
Regularly clean the motor housing using a damp cloth. Do
not use any abrasive or solvent-based cleaner.
Regularly open the chuck and tap it to remove any dust from
the interior (when fitted).

Protecting the environment

Separate collection. This product must not be
disposed of with normal household waste.
Should you find one day that your Black & Decker product
needs replacement, or if it is of no further use to you, do not
dispose of it with household waste. Make this product
available for separate collection.
Separate collection of used products and packaging
allows materials to be recycled and used again.
Re-use of recycled materials helps prevent
environmental pollution and reduces the demand
for raw materials.
Local regulations may provide for separate collection of
electrical products from the household, at municipal waste
sites or by the retailer when you purchase a new product.
Black & Decker provides a facility for the collection and
recycling of Black & Decker products once they have
reached the end of their working life. To take advantage of
this service please return your product to any authorised
repair agent who will collect them on our behalf.
You can check the location of your nearest authorised repair
agent by contacting your local Black & Decker office at the
address indicated in this manual. Alternatively, a list of
authorised Black & Decker repair agents and full details of
our after-sales service and contacts are available on the
Internet at: www.2helpU.com.
At the end of their useful life, discard batteries with
due care for our environment:
Do not short-circuit the battery terminals.
Do not dispose of the battery(s) in a fire as this may
result in a risk of personal injury or an Explosion.
Run the battery down completely, then remove it from
the tool.
Batteries are recyclable. Place the battery(s) in a suitable
packaging to ensure that the terminals cannot be short-
circuited. Take them to any authorised repair agent or a local
recycling station.
ENGLISH
6