Charging The Appliance; Cleaning And Maintenance - Blaupunkt MSF701 Owner's Manual

MSF701
1. Protective cap
2. Shaver head (Frame with 2 shaving
foils and blade)
3. Blades
4. Shaver head's release buttons, 2x
5. On/off button

CHARGING THE APPLIANCE

If the appliance's battery charge is low or the battery is totally discharged, it needs charging. Insert the
power supply cord into the appliance and connect the power supply unit to the electrical grid.
The charging indicator of the appliance will then display its charging status. If the appliance is totally
discharged, the indication of its charging status may be delayed. This delay should be no longer than 2
minutes.
Having connected the appliance to the charger, you may continue using the appliance. However, do
not use the appliance in the vicinity of baths, showers, swimming pools or similar water tanks.
SHAVER OPERATION
Switch the shaver on with the On/Off button.
Move the shaver across the skin surface, stretching it gently.
Clean the shaving head after each use with the provided brush.
The appliance may be used for wet or dry shaving. If you use shaving foam or gel, rinse the shaver
regularly under a stream of tap water to prevent the shaving head from "clogging".
Note: Each shaver requires the skin and hair growth to adjust to the blade system applied. The first
shaves may not be perfectly accurate and the skin may be irritated. The adjustment period may last up
to 3 weeks.

CLEANING AND MAINTENANCE

Before cleaning check if shaver is not connected to power supply and it is turned off.
1. Daily cleaning after dry shaving
Depress both release buttons to release the shaver head. Pull the shaver head up and off. Tap the
shaver head gently over a sink to remove any hair. Without the shaver head mounted, use the On/Off
switch to switch the shaver on for approx. 5 – 10 seconds to dispel any hair from the shaver blades.
Firmly mount the shaver head on the shaver until the locking mechanism audibly engages. Place the
protective cap on the shaver. The shaver is now ready for use again.
2. Daily cleaning after wet shaving
Depress both release buttons to release the shaver head. Pull the shaver head up and off. Wash the
shaver head thoroughly under warm running water on the inside and outside. Carefully dry the shaver
head with a lint-free cloth or a paper towel. In the process, do not push the shaving foils in. Thoroughly
rinse off the top part of the shaver and the shaver blades under warm running water. Without the
shaver head mounted, use the On/Off switch to switch the shaver on for approx. 5 – 10 seconds to
dispel any hair from the shaver blades. Firmly mount the shaver head on the shaver until the locking
mechanism audibly engages. Place the protective cap on the shaver. The shaver is now ready for use
again.
3. User maintenance for the shaving foils and blades
To maintain the performance of your shaver and increase the service life of the shaving foils, you
should perform user maintenance on the shaving foils every two months as follows:
6. Socket for charging
7. Cleaning brush
8. Power cord with adaptor
9. Display, battery symbol
10. Display, plug symbol
11. Trimmer
4