JUKI LS-2342 Instruction Manual page 15

• CP-180
A
❽
❹
❶ ❷
B
❼
1) Simultaneously pressing switch ❶ and switch ❷ , turn
ON the power switch.
is displayed A in the indicator and the mode is
2)
changed over to the adjustment mode.
3) Turn the handwheel by hand until the main-shaft refer-
ence signal is detected. At this time, the degree of an
angle from the main-shaft reference signal is displayed
on the indicator B. (The value is the reference value.)
4) In this state, align one of the marker dots ❼ on the
handwheel with marker line ❽ on the pulley cover as
shown in the figure.
5) Press switch ❹ to finish the adjustment work. (The
value is the reference value.)
6) Turn the power OFF.
When checking the adjustment result, set
"Function setting No. 90; Initial sewing ma-
chine movement function" at "1: Initial oper-
ation - Sewing machine stops with its needle
up". Then, check whether or not marker dot ❼
is aligned with marker line ❽ . If they are not
aligned, carry out the adjustment again.
After checking the adjustment result, return the
setting of No. 90 to the previous setting. (Initial
value is "2. Initial operation: Sewing machine
turns in the reverse direction and stop with its
needle up".)
For the function setting procedure, refer to "18.
How to set the functions" in the Instruction
Manual for the CP-180.
– 13 –