Table of Contents
Advertisement
A
A: H
PPENDIX
Signal
Three long beeps
A long warbling tone (with ringer on)
Four short beeps
A
B: T
PPENDIX
In case of difficulty, please check the following Troubleshooting Guide
before seeking service.
Problem
No dial tone
10
S
ANDSET
OUND
ROUBLESHOOTING
Solution
• Check installation:
— Is the base power cord connected to a working
outlet?
— Is the Phone in Use light on?
— Is the telephone line cord connected to the base
unit and the wall jack?
• Disconnect the base from the wall jack and connect
another phone to the same jack. If there is no dial tone
in the second phone, the problem might be your
wiring or local service.
• Is the handset out of range of the base?
• Make sure the battery is properly charged (12 hours).
• Is the battery pack installed correctly? See page 8.
• Did the handset beep when you pressed the phone
button? Did the Phone in Use light come on? The
battery may need to be charged.
• Reset the security code by placing the handset in the
base for about 20 seconds.
S
IGNALS
Meaning
Page signal
Signals an incoming call
Out of range warning
G
UIDE
Advertisement
Table of Contents
