Table of Contents
Advertisement
Index
physical specifications, A-7
pin assignments for I/O connector (figure), 3-2
polarity
analog input, 2-4
analog output, 2-6
bipolar and unipolar signal range versus
gain (table), 3-5
port C signal assignments (table), 3-17
posttrigger mode, 3-23
power connections, 3-31
power requirement specifications, A-7
power-on state, 4-11
pretrigger mode, 3-24
pulse generation, 3-28
pulsewidth measurement, 3-29
R
RD* signal (table), 3-18
referenced single-ended mode. See RSE input
requirements for getting started, 1-2
RSE input
configuration, 2-5
definition (table), 2-4
recommended input configurations
(table), 3-7
single-ended connections for floating
signal sources, 3-11
S
sample counter, 3-22
sample-interval counter, 3-22
sampling rate (note), 4-10
signal connections
analog input signal connections
bipolar and unipolar signal range
versus gain (table), 3-5
common-mode signal rejection, 3-13
DAQCard-1200 User Manual
differential connections
floating signal sources, 3-8
grounded signal sources, 3-10
single-ended connections, 3-11
when to use, 3-8
exceeding maximum input voltage
ratings (caution), 3-4
floating signal sources, 3-6
ground-referenced signal
sources, 3-6
input configurations, 3-7
instrumentation amplifier, 3-5
pins, 3-4
recommended input configurations
(table), 3-7
single-ended connections
floating signal sources (RSE
grounded signal sources (NRSE
when to use, 3-11
types of signal sources, 3-6
analog output signal connections, 3-14
DAQ and general-purpose timing signal
connections
data acquisition timing
connections, 3-22
general-purpose timing
connections, 3-26, 3-27
pins, 3-22
power connections, 3-31
digital I/O signal connections
illustration, 3-16
pins, 3-15
port C pin connections, 3-17
timing specifications
mode 1 input timing, 3-19
mode 1 output timing, 3-20
mode 2 bidirectional
I-6
configuration), 3-11
configuration), 3-12
timing, 3-20
ni.com
Advertisement
Table of Contents
