Connecting The Signals; I/O Connector - DAQ DAQCard-1200 User Manual

Connecting the Signals

I/O Connector

Caution Connections, including power signals to ground and vice versa, that exceed any
of the maximum ratings of input or output signals on the DAQCard-1200 can damage the
DAQCard-1200 and the computer. NI is not liable for damage resulting from any such
signal connections.
© National Instruments Corporation
This chapter describes the signals on the DAQCard-1200 I/O connector.
Figure 3-1 shows the pin assignments for the DAQCard-1200
I/O connector. This connector is attached to the ribbon cable that extends
from the PC Card slot when the card is installed and the cable is connected.
3-1
3
DAQCard-1200 User Manual