Related Manuals for Aethlabs microAeth AE51
Summary of Contents for Aethlabs microAeth AE51
- Page 1 AE51 Flow Calibration Kit ® Operating Manual © 2016 AethLabs https://aethlabs.com...
- Page 2 AE51, then these USB drivers are already installed on your computer. If this there is an arrow denoting the direction is the first time using the microAeth AE51 with your computer then first install the of air flow through the flowmeter. Be microAethCOM software.
- Page 3 PC Software Installation release button on the lower side. 1. Always make sure that a filter strip is 1. Do not connect the microAeth AE51 5. Loosen the rubber cover on the front of installed in the microAeth AE51 when...
-
Page 4: Auto Flow Calibration
Some 2. When exchanging a filter strip in the instruments, especially older units that microAeth AE51, make sure that it is have not had pump upgrade service turned off. by AethLabs, may need to use the 3% tolerance setting. -
Page 5: Manual Flow Calibration
4. Make sure that the flow calibration kit is in the instrument. connected to the AE51. 10. The flow rate of the microAeth AE51 will change and the text box to the right 5. Connect the flowmeter and microAeth of Flow on AE51: should be populated AE51 to the computer with the software with the desired flow setpoint. - Page 6 The Write Values to Instrument button will prompt the user to select a previously saved flow calibration table file for upload to the AE51. Operating Manual - microAeth AE51 Flow Calibration Kit, Jul 2016, Rev 02 microAeth AE51 Flow Calibration Kit Operating Manual AethLabs...
Need help?
Do you have a question about the microAeth AE51 and is the answer not in the manual?
Questions and answers