Table of Contents
Advertisement
7. Connect your NAS server to the network by attach a LAN cable from the LAN
port located at the back of your NAS server.(At least one network connection is
required)
8. Plug the power cord into the power connector on you NAS server.
9. Make sure the power switch on the power supply is in on position.
10. Press the power button on the left hand corner of your NAS server.
11. Wait for the server to boot up. The boot up process takes approximately 2
minutes.
2.2 Sliding Rails Installation
1. Make sure that you have the following the mounting parts for the sliding rails.
4 L-shaped brackets (see the left side of the photo)
l
8 x
"M4" size screws, 8 x "M5" size screws and 6 x "#6-32" size screws.
l
2. Take the sliding rail apart by sliding out the center slide. Push down the hook to
separate them. Pull the center slide all the way until it reaches the end.
#6-32
9
Advertisement
Table of Contents
