Installing Option Modules; Mechanical Installation Of Option Modules - ABB ACS880-11 Hardware Manual

Installing option modules



Mechanical installation of option modules

See section Overview of power and control connections
slots for each module. Install the option modules as follows:
WARNING! Obey the instructions in chapter
you ignore them, physical injury or death, or damage to the equipment can
occur.
1. Stop the drive and disconnect it from the power line. Wait for 5 minutes and then
make sure by measuring that there is no voltage. See section
electrical work on page
2. Remove the front cover(s) if not already removed (see page 100).
3. For frame R3, pull the control panel holder up.
4. Insert the module carefully into its position on the control unit.
16 before you start the work.
Electrical installation – IEC 109
page 34 for the available
Safety instructions on page 13. If
Precautions before