Operation - Denso UB1 Operating Manual

5. OPERATION

Connect the air-conditioner power supply cord to a 10A power outlet.
Always ensure that the power supply cord is fully uncoiled before operating the
unit to prevent overheating. The power cord must be routed so that it cannot be
damaged during use or when in transit.
The Power Indicator (I) will illuminate briefly when the power supply is connected and
switched on.
5.1 Switch the air-conditioner on by pressing the Power button (A) on the remote
control while aiming the control in the direction of the air distribution unit
Infrared Remote Control Receiver (J). The air-conditioner will beep and the Power
Indicator (I) will illuminate to acknowledge the signal.
5.2 Set the desired operating mode (Fan, Cooling or Heating), Fan Speed (Low, Med
or High) and the desired temperature (16-30°C). The interior fan, exterior fan and
compressor will operate automatically depending upon the settings chosen. Fan
speed should be selected manually to the lowest level that achieves the desired
room temperature.
Once the desired room temperature is reached, the air-conditioner will cycle the
compressor and exterior fan to maintain the temperature level.
If the air-conditioner cannot reach a comfortable temperature in cooling mode, increase the
fan speed to increase performance.
The desired temperature can be adjusted if you are too hot or cold.
5.3 Switch the unit off by pressing the Power button (A) on the remote control. The
Power Indicator (I) will extinguish.
Alternatively, the unit can be set to switch off automatically using the Off Timer. While
the unit is switched on, press the Timer button (E) on the remote control repeatedly
until the display shows the desired number of hours until the air-conditioner will switch
off.
NOTE:
Whenever the remote control is used, it must be aimed in the direction of the Infrared Remote Receiver (J)
on the Air Distribution Unit from a distance of less than 8m. The air distribution unit will beep once and the Power
Indicator (I) will flash once to acknowledge the command.
CAUTION
7