Initialization; Reset Option In Hdmi Diagnostics Mode; Factory Reset Mode - Denon AVR-S730H Troubleshooting Manual

Introduction How to operate

Initialization

The Limit setting in the HDMI DIAGNOSTICS mode is stored per input.
Please note that the limit mode settings backup memory will not be initialized (reset) using the initialization (reset) method described in the instruction manual.
There are two ways to reset the limit mode settings.

Reset option in HDMI DIAGNOSTICS mode

Limit mode settings that are made in the HDMI Diagnostics mode are reset to the
factory default values.
However, settings other than HDMI Diagnostics (e.g. Speaker setup, Video Setup,
Audio Setup) are not reset.
1
Select "5 Limit Mode" from the HDMI Diagnostics menu.
2
Select "Reset" from the Limit mode menu.
3
Select "All source", then press ENTER.
Cable Test Limit mode

Factory Reset mode

All settings including the Limit mode setting of HDMI Diagnostics mode are reset to
the factory default values. (except for Network setup)
1
Press the POWER button to turn off the AV Receiver.
2
While holding down buttons [A] and [B] simultaneously, press
POWER button.
3
Release the buttons after confirming that the front panel display
flashes at 1-second intervals.
AVR-S730H
AVR-S930H
AVR-X1400H
AVR-X2400H
8
Log & EDID
Model Button [A]
TUNER
PRESET CH +
ZONE2 SOURCE
Troubleshooting
Button [B]
TUNE -
DIMMER