Operation; Installing Hook - Makita DDF484 Instruction Manual

Graduation
Machine screw
Wood Soft wood
screw (e.g. pine)
Hard wood
(e.g. lauan)
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Installing or removing driver bit/
drill bit
1
2
1. Sleeve 2. Close 3. Open
counterclockwise.

Installing hook

2
1. Groove 2. Hook 3. Screw
the hook, insert it into a groove in the tool housing on
loosen the screw and then take it out.
1 2 3 4 5 6
M4
–
–
3
1
3
7 8 9 10 11 12
M5
3.5 x 22 4.1x 38
3.5 x 22
Installing driver bit holder
Optional accessory
1
2
1. Driver bit holder 2. Driver bit
Fit the driver bit holder into the protrusion at the tool foot
on either right or left side and secure it with a screw.
When not using the driver bit, keep it in the driver bit
holders. Driver bits 45 mm-long can be kept there.

OPERATION

CAUTION:
all the way until it locks in place. If you can see the
red indicator on the upper side of the button, it is not
locked completely. Insert it fully until the red indicator
cannot be seen. If not, it may accidentally fall out of
you.
CAUTION:
extremely, reduce the load or stop the tool to
avoid the tool damage.
other hand on the bottom of the battery cartridge to
control the twisting action.
8 ENGLISH
13 14 15 16 17 18
M6
–
4.1x 38
Always insert the battery cartridge
When the speed comes down
19 20 21
–