Ramtron VersaKit-30 Series User Manual page 21

VersaKit-30xx
When a breakpoint is set in the code, the breakpoint reference number will be displayed in red right next to the code line.
The breakpoint toolbar will then display the active breakpoint. Double clicking again on a given code line where a
breakpoint has been set will disable that breakpoint.
Figure 24: Setting Breakpoint by double clicking on a code line
Once a breakpoint is set, click on run . The processor will then start executing code at full speed until a breakpoint is
reached or halted .
Figure 25: Breakpoint reached
_______________________________________________________________________________________________
www.ramtron.com
page 21 of 28