Advertisement
VersaKit-30xx
5.4.2
Using the Versa Ware JTAG Debugger
Once the program is loaded into the VRS51L3074 Flash memory and the debugger is enabled, activate the debugger by
clicking on the debugger
button. Upon startup, the debugger will halt the processor at address 0x0000 and wait.
Figure 23: Versa Ware Debugger upon startup
Once the debugger starts, you can either run the program at full speed by clicking on run
or set a breakpoint anywhere
in the code by either double clicking on a specific code line and then pressing run
or by setting the breakpoint
manually. Alternatively, you can manually set breakpoints anywhere in the code by clicking the breakpoint setting
button
.
_______________________________________________________________________________________________
www.ramtron.com
page 20 of 28
Advertisement
