Advertisement
VersaKit-30xx
5.4 Getting Started Using the Versa Ware JTAG Software
Once the software is installed, it can be run directly from the setup program, or by clicking on the Versa Ware JTAG
shortcut created during the installation process.
5.4.1
Versa Ware JTAG programming interface
Upon startup, the software will attempt to connect to the VJTAG-USB interface.
Status Bar
Most of the functions provided by the Versa Ware JTAG software are executable via the action toolbar.
To download a HEX file into the VRS51L3074:
1. Ensure that the Versa-JTAG interface is properly connected to the H2 header of the development board.
2. Click on the synchronize
3. Click open
to select the HEX file to be programmed into the VRS51L3074.
4. Click erase then program
program will start.
_______________________________________________________________________________________________
www.ramtron.com
Action Toolbar
File Information Window
Figure 21: Versa Ware JTAG programming interface
button. The status bar should show: "VRS51L3074-40-Q waiting for instruction".
to erase and program the Flash. By default, after this process is complete, the
page 18 of 28
Advertisement
