Table of Contents
Advertisement
Software check and upgrade
Preparation to upgrade software
1) Start the CD burning software & create a folder named "UPG_ALL",
2) Then copy the Bin file (unify.bin.bin) into it,
3) Burn the data onto the blank CD.
A. Procedure for software upgrade
A) Upgrade software via Disc
1) Power on the set and insert the prepared Upgrade
CDR.
2) The set will starts reading disc & response with the
following display on TV screen:
Now searching for upgrade software!
Please wait...!
3) Press <ok> button to confirm, then screen will display :
Software upgrades for this player have been found,do you upgrade?
Cancel
4) Press Right cursor button to choose "Start", then press <OK>;
5) The software will updagrde and screen will display as below:
Upgrade is ongoing, Please wait...
Please do not unplug or switch off the device.
6) The screen will display as below when upgrading complete:
Upgrade has completed successfully!
Power off after 1s.
7) Restart the set.
B) Upgrade softwar via network:
1) Setup the network connection (See "Getting started">"Set up
network").
2) In the Home menu, select <Setup>-<Advanced>-
<Software update>-<Network>.
* You are prompted to start upgrading processes if upgrade
media is detected.
3) Follow the instructions on the TV screen to confirm update
operation.
* Once software updated is complete, this player automatically
truns off to standby.
4) Disconnect the power cord for a few seconds and connect again
to turn on the player.
C) Update software via USB Flash Drive:
1) Go to www.philips.com/support to check if the latest software
version is available for this player.
2) Download the software onto a USB flash drive.
3) Insert the USB flash drive to the USB jack of the rear panel.
4) In the Home menu, select <Setup>-<Advanced>-<Software
Updade>-<USB>.
5) Follow the instructions on the TV screen to confrim update operation.
* Once software update is complete, this player automatically turns to
standby.
6) Disconnect the power cord for a few seconds and connect again to
turn on the player.
Still
Start
Power Off
3-1
B. Read out the software versions to confirm upgrading
1) Power on the set and open the tray door.
2) Press <Home> button on the reomote control.
3) Select <Setup>, then press <OK>.
4) Select <Advanced>, press right cursor to choose
<Version Info.>, then press <OK>, the software version
and other information will display on the TV screen as below:
Model:BDP2XXX
Versions
System SW:X.XX
Ethernet MAC:XX-XX-XX-XX-XX-XX
For more information,frequently asked questions and sofeware updates,
please visit www.philips.com/support
Caution: The set must not be power off during
upgrading, otherwise the Main board will be
damaged entirely.
Advertisement
Table of Contents
